Inspection:
(1) If O-ring is damaged, replace with new one.
(2) If there is any dirt or foreign objects, clean up before re-assembly.
Note:
(1) Torque of oil strainer screen: 150 ~ 200 kg-cm.
(2) Lubrication Type: SAE 10W-40
Engine oil capacity
Engine disassembled : 900c.c.
Oil Change : 750 c.c.
(3) Check if there is any leakage after oil change. Warm the engine and check the
engine oil level again.
3.3 Final Drive Gear Oil
Place the motorcycle on the main stand for inspection. Clean grease around the drain plug.
Disassembly:
Oil refill plug.
Oil drain plug.
Note: Put an oil tray under the gearbox before removing the drain bolt plug.
Inspection: Check if the oil drain plug washer is damaged. Replace with new one if it is
damaged.
Drain gear oil.
Assembly:
Replace drain plug.
Refill gearbox oil.
Reinstall oil refill plug.
Note:
• Torque on drain plug: 90 ~ 150 kg-cm.
• Oil type: SAE 90 #
To Next Page
Loading...