Place a vessel under the engine, remove the sump plug and the oil level gauge.
(Note that on some engines the drain is also the oil strainer and is located at the bottom of
the sump)
After draining the oil, clean the oil level gauge (check the O-ring seal) and fit the drain
plug (strainer) again.
Tightening torque: 150 kg-cm
Add oil to the required level through the oil level gauge.
Lubrication Type: SAE 10W-40. Engine oil capacity - Engine disassembled:900c.c., Oil
change: 750c.c.
Replace the oil level gauge.
Note: Run the engine after a few minutes, then recheck the oil level.
To Next Page
Loading...