Need help?Do you have a question about the MONARCH INSTRUMENT PLS and is the answer not in the manual?
General| Brand | MONARCH INSTRUMENT |
|---|---|
| Model | PLS |
| Category | Measuring Instruments |
| Language | English |
Details the battery power source and procedures for turning the unit on and off.
Describes the input and output jacks for external triggering and synchronization.
Device generates its own timing signals; user adjusts flash rate without external input.
Device flash is triggered by an external signal source, synchronizing with events.
Device is plugged in for charging and is inoperable during this mode.
Allows selection between the flash (Strobe) and no-flash (Tachometer) operational modes.
Adjusts the flash pulse width, impacting perceived brightness and motion blur.
Saves the current flash rate setting to one of the available memory locations.
Recalls a previously saved flash rate setting from a designated memory location.
Configures the displayed engineering units, typically RPM or RPS.
Controls the activation of the display's backlight for improved visibility.
Sets the number of decimal places to be shown in the display.
Configures the active edge (rising or falling) for an incoming signal pulse.
Explains how the flash duration influences the degree of perceived blur on moving objects.
Adjusts flash pulse width by setting a specific degree of rotation for the visible effect.
Adjusts flash pulse width by setting a fixed duration in microseconds.
Details the visual indicator for low battery status and operational limits.
Provides the procedure for charging the internal Lithium Ion rechargeable batteries.
Instructions on removing and disposing of batteries and the unit according to regulations.
To Next Page
