7
second press will enter the Setup Mode. The top line of the display will show
SEtUP and the bottom line will show the setup options. Use the UP/DOWN
button ▲▼ to scroll through the setup options. Press the MENU button at
any time to select that setup option. Note that currently selected options are
indicated by the star icon ( ).
Setup options are in order as follows:
MODE > BRITE > SAVE > LOAD > UNITS > BKLIT > DECPT > INPUT
These options are described in the following sections. Note that the order
of the options within each setup option may change depending on current
operating settings.
5.1 MODE
Set the strobe into the fl ash (strobe) mode or the tachometer (no fl ash)
mode. When the display shows:
SETUP
MODE
Press the MENU button to enter. The mode can be set to Tach or Strobe.
Tach - No LED fl ash - use external input to show RPM
TACH
MODE
Press MENU to save and return to the main menu, or use UP/
DOWN button ▲▼ to change to:
Strobe - Internal generator - fl ash LEDs
STRBE
MODE
Press MENU to save and return to the main menu or press ◄ to return
to the main menu without saving. The unit will indicate DONE when the
value has been changed.
To Next Page
Loading...
Need help?
General
