MONARCH INSTRUMENT PLS - 5.2 BRITE (Brightness); 5.3 SAVE

8
5.2 BRITE (Brightness)
Adjust the fl ash pulse width and consequently the brightness. See Section
6.0. When the display shows:
SEtUP
BRITE
Press the MENU button to enter. Width can be set in degrees or
microseconds.
DEG - Set the fl ash width in degrees from 0.1° to 10.0°. Use the UP/
DOWN button ▲▼ to change the degrees in 0.1° steps. Note that
the decade being edited can be changed using the LEFT ◄ or
RIGHT ► buttons.
5.6
DEG
Press the MENU button to move to microseconds.
uSEC - Set the fl ash width in microseconds from 0.5 to 1300 µsec. The
display will default to a conversion of the degrees to microseconds
for the current fl ash rate.
1234
uSEC
To accept this press MENU again. To adjust the fl ash rate in
microseconds, use the ▲▼ button. Note that the decade being
edited can be changed using the LEFT ◄ or RIGHT ► buttons.
Press MENU to save and return to the main menu.
5.3 SAVE
Saves the current fl ash rate to a memory location. When the display
shows:
SEtUP
SAVE
Press MENU to select, use the UP/DOWN button ▲▼ to select a