9
memory location, press MENU to select the location. The fl ash rate is
shown on the top row, memory location on the bottom row (see below).
3600
SM 3 (SM = Save Memory)
Press MENU to save and EXIT OUT OF MENU. The unit will indicate
DONE when the value has been changed.
5.4 LOAD
Loads the saved fl ash rate from a memory location. Press MENU to
select, use the UP/DOWN button ▲▼ to select the memory location,
press MENU to select. The fl ash rate is shown on the top row, memory
location on the bottom row (see below).
3600
RM 3 (RM = Recall Memory)
Press MENU to recall fl ash rate and EXIT OUT OF MENU.
5.5 UNITS
Selects the engineering units for the display. When the display shows:
SEtUP
UNITS
Press MENU to select, use the UP/DOWN button ▲▼ to select the
units. The units depend on the MODE of the unit. The options are RPM/
RPS (Revolutions per Minute/Second).
Unit
RPM
Press MENU to save and exit back to the main menu or press ◄ to
return to the main menu without saving. The unit will indicate DONE
when the value has been changed.
5.6 BKLIT (Backlight)
Turns the display backlight on or off. When the display shows:
SEtUP
BKLIT
To Next Page
Loading...
Need help?
General
