Moog THE SOURCE

1. Play a desired key. (This sets up a general range of frequencies; it has no influence
on the actual frequencies generated.)
2. Touch BSQS3 'then touch QSE1 (program 10).
3. At this point, adjusting the Q^Xl control in the Mod section will change the Sample & Hold
rate and modify the apparent "pattern" of voltage changes.
4. To cancel the Sample & Hold effect, touch ■■Mia»ei. then touch |£fg£]again.
S&HFILT
This control (program 11) routes the random Sample & Hold voltage to the filter alone. The operational
procedure is the same as for program 10 (S & H).
EXT TRIG
If a slave synthesizer is interfaced with The Source (as described in the Interface section of this manual),
its playing status is determined by this switch.
Note: This switch defeats triggers only. The oscillators of the slave synthesizer will always be affected by
The Source's keyboard voltage. Keep this in mind when playing multi-keyboard setups.
A table is provided in Section II that lists the functions and actions of all Level 2 controls.
24