Moog THE SOURCE

As mentioned earlier, a high-quality leaderless cassette tape should be used. If the tape is to be reused, it must be
totally erased with a bulk eraser or demagnetizes Since, in the "verify" mode, each piece of data is counted and
compared to a master checksum, the presence of any additional or residual data will cause an error.
LEVEL 2 FUNCTIONS
The following is a quick reference chart for the functions of the Level 2 controls. All controls in this chart are
activated by touching the Level 2 control first.
Some of the controls activate a temporary function that ends when certain.conditions have been satisfied; i. e.,
touching 03233313 activates the arpeggiator record mode until 24 notes have been entered, at which time the
instrument's status changes. These temporary conditions are listed in STATUS WHEN ACTIVATED; eventual
status is listed under CONTINUAL STATUS.
CONTROL
STATUS WHEN ACTIVATED
CONTINUAL STATUS
Level 2 Seq Record Mode; sequence
begins recording with first note depressed,
Level 2 until raPM or another Level 2
control is touched-
Defeats
ARPEGGIO
Immediately reverts to Level 1.
CONTINUE
Continues Sequencer playback from
stopping point. After fjiziaattwi.
starts from beginning of last arpeggio
played.
Immediate Level 1.
PLAY 1
PLAY 2
Starts Sequencer playback from
beginning.
Immediate Level 1 (with Sequencer playback).
ARPEGGIO
Activates Arpeggiator. If key is
depressed, Arpeggiator shifts to record
mode. If ggimmm<jg is touched,
Arpeggiator plays back.
Arpeggiator is active; Level 1 (programs may
be chosen).
57