Moog THE SOURCE User Manual

1. This factory program is voiced with Sync on. Change the frequency of Osc 2 (with the Octave and Interval
controls) and note the change in tone color.
2. While holding down a key, switch
the two oscillators are, turning
alternately off and on. No matter how far apart in frequency
on will lock them together, eliminating any "beating."
3. Hold down any key and move the pitch wheel. When Sync is on, the pitch wheel becomes a "tone color
wheel." These dynamic tone color changes are useful in performance.
NOISE
Noise is an unpitched signal source. The noise generator outputs a signal called Pink Noise, a composite of low,
mid-range and high frequencies.
Touch program
VOLTAGE CONTROLLED FILTER
I I K6 TRACK
I STORE I
MEMORY
OSCIU-ATOR
FILTER CONTOUR
LOUDNEBB CONTOUR
I 0 I I S
MODIFIERS
5 4 H S&HFILT AUTO TRIG £X1
;ave verify loud
REC1 RtCZ stvr tUNilNUt flflTi ruu nz\. ri.«» ^m^uu^u ^^^. ^^^^ .^^^^^. ^^^^B ^^^^B SBCTIIMI _■■ ■ ■■■^■1 ^^^^|
PROGRAMS
1. Play any key. This factory program uses noise as the primary signal source; no single pitch predominates.
Factory programs 4, 14 and 15 use noise as a signal source (in varying intensities).
29

Moog THE SOURCE Specifications

General

Brand	Moog
Model	THE SOURCE
Category	Synthesizer
Language	English