Moomba Craz User Manual

36
© 2016 Skier’s Choice, Inc.
DRIVeR’s seaT & seaT aDjUsTMenT
Be careful of the articulating hinge. Do not place ngers or other objects in the hinge mechanism during use.
The driver’s seat may be adjusted forward or backward by moving the lever below the front of the seat. Use body pressure to move
the seat to the desired position. Release the lever then check to feel the seat lock into place.
After adjusting the seat, be sure that it has locked into place by pushing forward and backward until it has securely latched.
DO NOT attempt to adjust the driver’s seat while the boat is moving.
V-DRIVe engIne CoMPaRTMenT
To access the engine compartment, turn latch and pull to
raise the center sun deck lid. When the ski lockers and engine
compartment lids are closed, the upholstered lids double as a
cushioned sun deck.
The Rise-R Seat is a unique driver seat enhancement. The front
edge of the driver’s seat cushion lifts up to give
the driver a taller sightline.
To switch the seat to the raised position, use two hands to lift
and push the front edge of the seat cushion up and
back until it is sitting on the rear half of
the driver’s seat cushion.
To switch to the lower position, use two hands to
push the Rise-R seat cushion forward and down.

Moomba Craz Specifications

General

Ballast Capacity	3, 700 lbs
Beam	102 inches
Engine	Indmar Raptor 400
Engine Options	Indmar Raptor 400, Indmar Raptor 450
Length	22 ft