Moomba Craz User Manual

37
© 2016 Skier’s Choice, Inc.
skI PYlon
The ski pylon is only to be used to pull skiers. DO NOT use
the ski pylon to hoist the boat. Only use the lifting rings for
this purpose.
NOTE: With use the ski pylon may loosen. Should this occur,
see your Moomba Dealer for service.
fIRe eXTIngUIsHeR
A standard Coast Guard approved re extinguisher is provided
on all Moomba boats. The re extinguisher is located on the
port side behind the observer’s seatback.
(Refer to label instructions for use.)
The use of pylon extensions can severely effect the
overall handling of the boat. Follow pylon extension
manufacturer’s directions for mounting.
DO NOT mount any Pylon Extension on the rear pylon
(located at the rear sundeck).
gloVe boX
To open the glove box, press the black round cylinder down
while lifting the black nger tab. Once open, the lid is supported
by a spring.

Moomba Craz Specifications

General

Ballast Capacity	3, 700 lbs
Beam	102 inches
Engine	Indmar Raptor 400
Engine Options	Indmar Raptor 400, Indmar Raptor 450
Length	22 ft