4
© 2016 Skier’s Choice, Inc.
Drain Plugs (Securely in place?)
Life-Saving Devices (One for every person on board?)
Steering System (Working smoothly and properly?)
Fuel System (Adequate fuel? Leaks? Fumes?)
Battery (Fully charged? Cable terminals clean and tight?)
Engine (In neutral?)
Capacity Plate (Are you overloaded or overpowered?)
Weather Conditions (Is it safe to go out?)
Electrical Equipment (Lights, horn, pump, etc.?)
Emergency Gear (Fire extinguisher, bailer, paddle, anchor & line, signaling device, tool kit, etc.?)
Bilge Pump (Working properly?)
NOTE: Bilge pump should be checked prior to each use to ensure proper operation.
DAILY CHECKLIST
Check BEFORE running your boat (where applicable).
Engine Oil Level
Transmission Lubricant Level
Engine Drain Plug, Transom Drain Plug and Center Drain Plug
Leakage (Fuel, water lines and connections)
Check BEFORE running your boat.
Oil Pressure: Refer to Engine Owner’s Manual.
Water Temperature: 160 - 180 degrees for raw water systems (water is not recirculated), and 180 - 200 degrees for closed
cooling systems (water is recirculated).
Idle RPM: (650 - 750) in gear.
Maximum Forward RPM: Refer to Engine Owner’s Manual.
Shifting Linkage (Forward, Neutral & Reverse).
Check engine compartment for gasoline vapors.
Operate blower for four minutes before starting the engine.
Always operate blower below cruising speed.
NOTE: Please refer to your Engine Owner’s Manual for maximum RPM and engine break-in procedure.
GASOLINE VAPORS CAN EXPLODE. It is very important to check for fuel spillage or leaks prior to each use of
your boat.
DO NOT operate engine without cooling water flowing through water pump, or pump will sustain damage and
subsequent engine damage may result!
To Next Page
Loading...
Need help?
General
