Moomba Craz User Manual

40
© 2016 Skier’s Choice, Inc.
boW eYe
lIfTIng RIngs
Two lifting rings are located on the transom.
NOTE: The lifting rings should be the only point of attachment
for lifting cables. (See Hoisting Instructions.)
The bow eye is located at the front of the hull below the rub rail.
It is the point of attachment to lead the boat onto the trailer and
to secure the boat to the trailer or to a tie-o when docking.
NOTE: See Hoisting Instructions before using the bow eye
to hoist the boat.
DO NOT use the bow eye ONLY to hoist the boat. You must
use a sling with the bow eye when hoisting the boat. Use
only the designated lifting rings to hoist the boat. (See
Hoisting Instructions.)
The ski platform is attached to the boat with detachable
brackets. The platform may be removed from the boat by 1. Set
platform on bracket. 2. Locate lower pin. 3. Locate locking pin
through brackets. 4. Swing locking arm over end of pin.
sTanDaRD DeTaCHable bRaCkeT

Moomba Craz Specifications

General

Ballast Capacity	3, 700 lbs
Beam	102 inches
Engine	Indmar Raptor 400
Engine Options	Indmar Raptor 400, Indmar Raptor 450
Length	22 ft