54
Handbrake
The handbrake on the your vehicle only operates the rear wheel brakes. The
handbrake lever is a conventional type handbrake. Pull the lever upwards until the
brake begins to operate and holds the vehicle in a stationary position securely.
To release the handbrake push the button on the end of the lever and slowly
release the lever ensuring that the vehicle will not move or roll unless required.
Ensure the handbrake is fully released before driving the vehicle. Failure to do
so may result in damage to the brake system and drive-train components.
NOTICE When the vehicle is stationary the handbrake should be fully
engaged and the automatic gearbox selector set to Park.
The foot pedals in the vehicles are set out in the standard format with the
accelerator pedal on the right, brake pedal in the centre, and a foot rest on the left..
WARNING It is essential that all foot-operated controls are free of
trim and any other items that may interfere with their operation.
WARNING When driving, suitable footwear should be worn. Wearing
incorrect or no footwear may inhibit your ability to operate the foot
pedals resulting in an accident. It is essential that all foot pedals are free
of obstructions that may interfere with their operation.
Foot Brake
Allow the brake system to fully bed in before heavy braking is performed unless
in an emergency or other cases when heavy braking is required. The required
pedal eort will be reduced as the brake system beds in.
WARNING The brake system on your Morgan is a servo-assisted system.
Braking assistance is only supplied whilst the engine is running. Do not
coast with the engine o. This will result in a loss of brake performance
which may result in an accident causing serious injury or death.
Accelerator (Throttle Pedal)
The accelerator on your Morgan is an electronically operated accelerator system.
NOTICE Do not push the accelerator pedal when starting the vehicle.
DRIVING CONTROLS
To Next Page
Loading...
