SETTING THE BATCH QUANTITY
PRESS THE MODE SWITCH UNTIL THE BATCH LAMP IS ON. ROTATE THE VALUE DIAL TO
DETERMINE THE BATCH SIZE.
RUNNING THE MACHIHE
ONCE ALL OF THE PREVIOUS SETTINGS HAVE BEEN ADJUSTED THE MACHINE IS READY
TO START FOLDING. WHILST THE MACHINE IS IN OPERATION, THE DISPLAY CAN
EITHER SHOW THE RATE AT WHICH THE SHEETS ARE BEING FOLDED (SHEETS PER
HOUR) OR SHOW THE TOTAL AMOUNT OF FOLDED DOCUMENTS. THE DIAGRAM BELOW
SHOWS THE DISPLAY WITH THE MACHINE OPERATING IN THE RATE MODE. TO CHANGE
BETWEEN MODES, OPERATE THE MODE SWITCH UNTIL EITHER THE TOTAL OR RATE LAMP
IN ON.
PRESS THE RUN SWITCH, THIS WILL START BOTH DRIVE MOTORS. THE SPEEDS OF
BOTH MOTORS CAN BE ADJUSTED INDEPENDENTLY AT ANYTIME DURING THE MACHINES
OPERATION. NOTICE THE MOTORS LAMP WILL NOW COME ON.
PRESS THE AIR BUTTON TO ON, THIS WILL START THE COMPRESSOR. NOTICE THE
VACUUM LAMP WILL NOW COME ON.
PRESS THE SAMPLE SWITCH TO FEED A SINGLE SHEET IN ORDER TO EXAMINE THE
FOLD. IF THE OPERATOR IS SATISFIED WITH THE RESULT, THE FEED SWITCH CAN
THEN BE OPERATED.
THE DISPLAY IN RATE MODE,
THE DISPLAY IN TOTAL COUNT MODE
11
To Next Page
Loading...
