Morris C2 Contour - Application; Tractor; Operation

Operation
5-2 August 2014 C2 Contour Air Drill
CAUTION
BE ALERT
SAFETY FIRST
REFER TO SECTION 1 AND REVIEW ALL
SAFETY RECOMMENDATIONS.
Application
The Morris CONTOUR DRILL utilizes independent
parallel link openers. Each opener moves independently
of the frame and each other to follow every contour of the
land closely. The unique design of the opener allows
the Morris CONTOUR DRILL to be used in a variety
of seeding applications from conventional to zero till
applications.
Tractor
Tires
• Proper ballast and tire pressure are required when
pulling heavy implements.
• Consult your tractor operator’s manual and follow all
recommended procedures.
Hydraulics
• Wipe all hydraulic ttings and couplers with a clean
cloth to avoid contaminating the system.
• Check that hydraulic reservoir is lled to the proper
level.
Drawbar
• Centre and pin in a xed position for easier hitching
and greater stability.
Warning
Do not permit smoking, sparks or an open
flame where combustible fuels are being used.
Keep the work area well ventilated.
Warning
Do not search for high pressure hydraulic
leaks without hand and face protection. A tiny,
almost invisible leak can penetrate skin, that
requires immediate medical attention.