Maintenance
6-4 August 2014 C2 Contour Air Drill
Lubrication
Greasing pivot points prevents wear and helps restrict
dirt from entering. However, once dirt does enter a
bearing, it combines with the lubricant and becomes
an abrasive grinding paste, more destructive than grit
alone.
• Apply new lubricant frequently during operation to
ush out old contaminated lubricant.
• Use a good grade of lithium based grease.
• Use a good grade of machine oil.
• Clean grease ttings and lubricator gun before
applying lubricant.
Refer to the photos for grease tting locations.
1. Wheel Hubs
• Grease every 500 hours or seasonally, whichever
occurs rst.
2. Gauge Wheel Castor Pivot
• Grease every 100 hours.
3. Packer Wheel Hubs
• Grease every 5,000 acres (2,000 hectares) or
seasonally, whichever occurs rst.
2
1
3
To Next Page
Loading...