Mortara ELI 230 - EMC Compliance and RF Safety

USER SAFETY INFORMATION
viii
FCC Compliance Statement for the WAM
In the United States use of this device is regulated by the Federal Communications Commission (FCC). The WAM
with its antenna complies with FCC’s RF exposure limits for general population/uncontrolled exposure.
FCC Warning (Part 15.21): Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the device.
WAM FCC ID: HJR-WAM2500
UTK FCC ID: HJR-UTK2500
These devices comply with Part 15 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Industry Canada Compliance Statement
These devices comply with RSS-210 of the Industry Canada rules. Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
WAM IC: 3758B-WAM2500
UTK IC: 3758B-UTK2500
The term “IC:” before the certification/registration number only signifies that the Industry Canada technical
specifications were met.
Note(s)
• Patient movements may generate excessive noise that may affect the quality of the ECG traces and the proper
analysis performed by the device.
• Proper patient preparation is important to proper application of ECG electrodes and operation of the device.
• There is no known safety hazard if other equipment, such as pacemakers or other stimulators, is used
simultaneously with the device; however, disturbance to the signal may occur.
• The WAM LEDs will automatically start flashing if the batteries have been discharged below 1.0 volts.
• During normal WAM/AM12 operation, the green LED will display continuously.
• If the WAM battery cover is opened during transmission, the device will stop transmitting. The battery must be
reinserted and the cover must be applied to resume operation.
• The WAM will automatically turn off (LEDs off) if the battery has been severely discharged.