GENERAL TECHNICAL INFORMATION
2 - 27
Griso V1100
• Remove both pins.
• Remove the vibration damper.
• Remove one pad at a time.
WARNING
Do not operate the brake lever when the pads
are not in place or the calliper pistons might
come out of their housing, thus causing brake
fluid leakage.
• Install two new pads, fit them so the holes match those
on the calliper.
WARNING
Always change both pads and ensure that they
are correctly in place inside the calliper.
• Fit the vibration damper; remember that the arrow must
indicate the direction of travel.
• Insert both pins.
• Fit both split pins.
• Pull the brake lever several times to take the pistons
against the pads.
• Check the brake fluid level.
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
To Next Page
