IMPORTANT
IN THE EVENT OF MALFUNCTION OF THE BATTERY, THE ABS - MGCT SYSTEM
TURNS OFF.
02_76
MGCT SYSTEM CALIBRATION PROCEDURE
In order to maintain the effectiveness of the MGCT system following the replacement
of one or both tyres or in the case of serious wear, causing a non-compliant behaviour
of the MGCT, a calibration procedure of the system must be performed as follows on
a straight flat stretch of road.
Check that the tyres are inflated to the correct pressure before calibrating the
MGCT system.
• Allow the engine to run in idle for at least 5 seconds.
• Check that the MGCT is activated at level 1 or 2. Otherwise, activate it.
• Pull the clutch lever while pressing the starter button (3) for at least 5 seconds. The
activation of the process will be confirmed by the MGCT warning light (2) turning on
with fast flashing.
• Accelerate to a constant speed of 18.64 mph (30 km/h) in second gear, and maintain
this speed for at least 8 seconds.
• The end of the procedure will be indicated by the MGCT warning light (2) turning off.
The MGCT system is active.
• Once the procedure is completed, it is necessary to switch the ignition key to (OFF)
and wait for at least 60 seconds before being able to switch again to (ON).
• In case of failure to complete the procedure within 2 minutes, the MGCT warning
light (2) will stay on steady and the MGCT system will remain off until switching to
(OFF).
• To reactivate the MGCT system, it must be switched again to (ON). It is however
necessary to repeat the process until it succeeds.
82
To Next Page
Loading...
