03_04
Rear shock absorbers adjustment (03_04, 03_05)
The shock absorber has an adjuster ring (1) in order to regulate the spring preload
(2).
NOTE
IT IS POSSIBLE TO VARY THE PRE-LOAD OF THE SHOCK ABSORBERS DE-
PENDING ON THE LOAD ON THE VEHICLE (PASSENGER OR HEAVY LOAD).
IMPORTANT
TO PREVENT DAMAGE TO THE ADJUSTER SCREWS (1), NEVER FORCE THEM
BEYOND THE END OF TRAVEL IN EITHER DIRECTION.
03_05
•
Use the adjuster ring nut (1) to adjust the preload of the spring (2) with a hook
spanner (3);
•
Screw to increase pre-loading; and vice versa, screw to reduce it.
IMPORTANT
FOR PROPER VEHICLE STABILITY IT IS ALWAYS A GOOD IDEA TO MAKE
SURE THAT BOTH SHOCK ABSORBERS ARE SET TO THE SAME POSITION. IF
NECESSARY, CONTACT AN Official Moto Guzzi Dealership.
95
To Next Page
Loading...
