01 • Press SEL button
the times necessary
until the T.PAUSA LED
starts to flash.
02 • Press SET button.
The T.PAUSA LED
starts to flash quickly.
03 • Wait the desired
time for pause time.
(Eg 30 seconds)
04 • Press SET button.
T. PAUSA LED stays lit
and the pause time
is set.
. PROGRAMMING . PROGRAMMING
MAIN MENU EXTENDED MENU
• T. PAUSA | PROGRAMMING PAUSE TIME FOR AUTOMATIC CLOSING MAX MIN
• EXTENDED MENU ACCESS
This function allows you to set the time that the gate remains open after the end of the
opening maneuver. After this time, the control board automatically initiates the closing.
The control board is supplied by the manufacturer without automatic closure.
To access the Extended Menu 1 functions, follow these instructions:
The control board is supplied with extra functions that can be activated through the
extensed menu 1.
Activate or change the pause time for automatic closure:
Disable the automatic closing:
01 • Press SEL button
the times necessary
until the T.PAUSA LED
starts to flash.
01 • Continuously
press the SET button
for 5 seconds.
02 • Double-press
the SET button within
2 sec! The T.PAUSA
LED turns off and
the function stays
disabled.
02 • The T.MOT.
PED and T.PAUSA
LEDs start to flash
alternately.
EXTENDED MENU 1
LED LED OFF LED ON
• CODE
Step by Step Mode Automatic mode
• CODE PED.
Electric brake = OFF Electric brake = ON
• IN.CMD.AP
Present Man = OFF Pres. APCH or CH = ON
• LAMP/CORT
Slowdown = OFF Slowdown = ON
• PGM. AUT.
Follow Me = OFF Follow Me = ON
• T. MOT.
PGM at distance = OFF PGM at distance = ON
• T. MOT. PED
Alternated flashing signal with LED T. PAUSA
• T. PAUSA
Alternated flashing signal with LED T. MOT. PED
After entering the Extended Menu 1, you have 30 seconds to select any function
of this menu (using the SEL and SET keys). After 30 seconds without pressing any
button, the control board returns to the main menu.
To Next Page
Loading...