B
A
A
A
B
A
B
A
A
B
A
B
B
A
A
A
B
B
STANDARDS TO FOLLOW
TECHNICAL CHARACTERISTICS
CONNECTIONS SCHEME
SEL/SET BUTTONS
CONNECTORS DESCRIPTION
MOTOR'S STRENGH AND SPEED
PROGRAMMING PRE-RECOMENDATIONS
FUSES
LEDS
CONDITIONS AND PRE VERIFICATIONS
ESSENTIAL INSTALLATION STEPS
CONTROL BOARD INSTALLATION
PREINSTALLATION WARNINGS
PARAMETERS TO TAKE CARE
EXTENDED MENU 2
INSTRUCTIONS FOR FINAL CONSUMERS
OTHER INFORMATION
INSTRUCTIONS FOR SPECIALIZED INSTALLERS
MAIN MENU
COMPONENTS TEST
EXTENDED MENU 1
PHOTOCELLS AND TRANSMITTER TESTS
. SAFETY INSTRUCTIONS
. THE CONTROL BOARD
. INSTALLATION
. PROGRAMMING
. MAINTENANCE
. TROUBLESHOOTING
ATTENTION:
Importance of the Manual:
• It is important for your safety that these instructions are followed.
• Keep these instructions in a safe place for future reference.
Responsibility:
• The ELECTROCELOS S.A. is not responsible for the improper use of the product, or other
use than that for which it was designed.
• The ELECTROCELOS S.A. is not responsible if safety standards were not taken into
account when installing the equipment, or for any deformation that may occur.
• The ELECTROCELOS S.A. is not responsible for insecurity and malfunction of the product
when used with components that were not sold by the them.
• The ELECTROCELOS S.A. informs that, to guarantee greater compatibility and proper
functioning, install only components MOTORLINE.
Mechanism use:
•This product was designed and manufactured strictly for the use indicated in this
manual.
• This control board is not appropriate for inflammable or explosive environments.
• Any other use not expressly indicated may damage the product and / or can cause
physical and property damages, and will void the warranty.
• Do not make any changes to the automation components and / or their accessories.
• Control board for indoor use with 230V connection.
• Keep remote controls away from children, to prevent the automated system from being
activated involuntarily.
• The customer shall not, under any circumstances, attempt to repair or tune the
automatism. Must call qualified technician only.
To Installer:
The installer must have certified professional knowledge at the level of mechanical
assemblies in doors and gates and control board programmation. He should also be
able to perform electrical connections in compliance with all applicable regulations.
• The installer should inform the customer how to handle the product in an emergency
and provide him the manual.
. SAFETY INSTRUCTIONS. CONTENT
STANDARDS TO FOLLOWINDEX
To Next Page
Loading...