. PROGRAMMING . MAINTENANCE
OTHER INFORMATION PARAMETERS TO TAKE CARE
• CONTROL BOARD'S RESET
• VERIFICATIONS
• ELIMINATION
• LEDS MANAGEMENT
If you need to restore the control unit to the factory settings, follow these steps:
Frequently check the installation for signs of lack of tightness or lubrication, imbalance
during functioning and traces of wear or deterioration.
Also check the condition of the installation and external components (switch, keyboard
or push buttons) and safety devices (photocells, safety edge) functioning. These are
exposed to external agents that may shorten their lifetime.
If the device requires repair, bring/send it to our service center.
At the end of its working life, the device must be removed from the place by a qualified
installer who must take into account all precautions and safety measures during the
procedure.
Never place the control board in household waste or uncontrolled landfills as it may
contaminate the environment. The control board must be placed in appropriate
recycling containers so that all components are separated according to their materials.
After 3 minutes of inactivity in the programming process, the control board automatically
turns off all the LEDs in order to save energy.
A simple click on a button (SEL, SET or programmed transmitter) will turn on the LEDs of
the programmed functions.
Before performing any maintenance, disconnect the control board from the
electric current.
01 • Press the SEL
and SET buttons
simultaneously for 10
seconds.
02 • All the LEDs
will light up
simultaneously and
then off, completing
the operation.
To Next Page
Loading...