Troubleshooting
51
Message not
received
Confirm radios have the same channel and interference eliminator
code settings.
Make sure
M
is
NOT
being pressed while trying to listen.
Reposition, replace, or recharge batteries.
If QuieT6000
feature is on, transmit call tone before talking.
If QuieT6000
feature is on, with only VibraCall selected, a
received call must be acknowleged by pressing any button (or a
VOX activation) before the radio can receive any incoming
transmissions.
Obstructions and operating indoors, or in vehicles, may interfere --
change location.
Verify that the radio is not in Scan mode.
Eavesdrop
Reducer
code is on, or setting does not match other
radios; all radios must use the same Eavesdrop
Reducer
code.
Heavy static or
interference
Radios are too close, they must be at least five feet apart.
Radios are too far apart or obstacles interfering with transmission.
Talk range is up to two miles in clear, unobstructed conditions.
Channel and/or
code locked
Make sure menu is unlocked. Unlock by pressing
\
for three
seconds.
Symptom Try This:
2 T6200 body.fm Page 51 Tuesday, February 20, 2001 3:36 PM
To Next Page
Loading...
Need help?
General
