Gauge Battery Charge
Top Display:
10% or less (at 10%, the gauge begins blinking)
4.1.2
Accessing the Battery Info screen
This feature displays the current capacity and charges cycles of your battery when an IMPRES battery
is powering your radio. This feature must be enabled in your radio to see the information.
Procedure:
1 or to Batt.
2 Press the Menu Select button directly below Batt.
Your radio displays the following result:
Charge Percentage
Percentage of current battery capacity.
Remaining Capacity
Remaining power of the battery in mAh.
Estimated Charges
Number of charges cycles the battery has gone through.
3 To return to the Home screen, press the Menu Select button directly below Exit.
4.2
LED Indications
The Status LED shows the operational status of your radio. A qualified technician can permanently
disable the LED indication by preprogramming it.
Table 1: LED Indications
Indication Status
Solid red Radio is transmitting.
Blinking red Radio is transmitting at low battery condition or detects an incompatible
battery.
Double blinking red Radio is transmitting an emergency alarm or call.
Rapid blinking red Radio has failed the self-test upon powering up or encountered a fatal er-
ror.
Solid yellow Channel is busy in conventional mode.
Blinking yellow Radio is receiving a secured transmission.
Solid green Radio is powering up or is on a non-priority channel while in the Scan List
Programming mode.
MN004476A01-AE
Chapter 4: Status Indicators
31
To Next Page
Loading...
