Motorola APX 8000H - Emergency Operation; Tactical;Non-Revert

If the call alert page is not acknowledged, you hear a low tone and the display shows No
acknowledge. Press the Menu Select button directly below Ok to return to the main screen
of Contacts.
• Sending a call alert page using the radio menu Call :
a.
or to Call .
b. Press the Menu Select button directly below Call .
c.
or to select the alias or ID, and press the PTT button to initiate the call.
If the target radio does not respond after a preprogrammed period of time, the display shows
Send page?.
d. To send the call alert page, press the Menu Select button directly below Yes . To exit the
screen without sending the call alert page, press the Menu Select button directly below No .
The display shows Paging...<Alias>.
If the call alert page is sent successfully, you hear a tone and the display shows Ack
received. The radio returns to the Home screen.
If the call alert page is not acknowledged, you hear a low tone and the display shows No
acknowledge. Press the Menu Select button directly below Ok to return to the main screen
of Contacts.
6.7
Emergency Operation
The Emergency feature is used to indicate a critical situation. An emergency signal overrides any other
communication over the selected channel.
Your radio supports the following Emergency modes:
• Emergency Alarm
• Emergency Call
• Emergency Alarm with Emergency Call
• Silent Emergency Alarm
One channel supports only one Emergency mode. The radio responds differently when pressing the
preprogrammed Emergency button in each channel.
Your radio is also programmed to operate in one of the following conditions:
Tactical/Non-Revert
The radio sends an emergency alarm and/or makes an emergency call on the current channel.
Non-Tactical/Revert for Conventional System
The radio reverts to the preprogrammed emergency channel to send an alarm and/or make an
emergency call.
Non-Tactical/Revert for Trunking System
The radio reverts to the preprogrammed emergency talkgroup (trunking system) or channel
(conventional system) to send an alarm and/or make an emergency call.
Man Down is an alternate way to activate the Emergency feature. For more information, see Man
Down on page 72.
Contact your system administrator for more information.
MN004476A01-AE
Chapter 6: Advanced Features
64