Motorola APX 8000H - Talkgroup Call Feature (Conventional Operation Only)

The display shows the last transmitted or received ID.
2 To select the required ID, perform one of the following actions:
• Press the Menu Select button directly below Cnts to scroll through and select the required
ID.
• Press the Menu Select button directly below LNum to go to the last number dialed.
•
or to the required ID.
3 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from your mouth.
4 Press and hold the PTT button to start the Selective Call.
The display shows the ID of the target radio.
5 Release the PTT button to listen.
6 Press to return to the Home screen.
6.2.2
Talkgroup Call Feature (Conventional Operation Only)
This feature allows you to define a group of conventional system users so that they can share the use
of a conventional channel.
NOTICE: Encryption keys are associated to talkgroups. When talkgroups are associated,
encryption keys are changed by changing the active talkgroup. See Secure Operations on page
84 for more information.
6.2.2.1
Selecting a Talkgroup
Procedure:
1
or to Tgrp and press the Menu Select button directly below Tgrp.
The display shows the last Talkgroup that was selected and stored.
2 Perform one of the following actions:
• or to Preset for the preset preprogrammed Talkgroup.
• or to the required Talkgroup.
3 Press the Menu Select button directly below Sel to save the currently selected Talkgroup and
return to the Home screen.
If the encryption key associated to the new Talkgroup is erased, you hear a momentary key fail
tone and the display shows Key fail.
If the encryption key that is associated to the new Talkgroup is not allowed, you hear a
momentary key fail tone and the display shows Illegal key.
4 Press
to return to the Home screen.
6.2.3
Sending a Status Call
When and where to use: This feature allows you to send data calls to the dispatcher about a
predefined status.
MN004476A01-AE
Chapter 6: Advanced Features
52