2-1
DEC 2010
Installation 2
Chapter 2: Installation
Overview
To install the Desktop CPEi 885 Series, review the following sections:
• Before You Begin
• Easy Setup
Before you Begin
Before you begin installation, check that you have received the following items with
your Desktop CPEi 885:
In addition, you need:
•A computer
• An RJ-11 telephone cable (optional). Two RJ-11 telephone cables are required if
your service provider has supplied you with two telephone numbers.
Easy Setup
The CPE is easily set up in your home. Basic installation equipment needed are the
power adapter, Ethernet cable, a PC or laptop computer and the CPE device.
If you want to use the VoIP functionality, you need an RJ-11 phone cable and a
telephone.
Perform the following tasks before attaching the power cord or powering up the unit:
• Stand the CPE on a flat surface.
• Plug the AC power adapter cord into an AC outlet.
• Plug one end of the Ethernet cable into the Ethernet connector on the back of the
unit.
• Plug the other end of the Ethernet cable into the Ethernet connector of your
computer.
• To use VoIP functionality of the phone, plug one end of the phone line into the
activated phone connector on the back of the unit. Phone line activation is
dependent upon your service contract.
• Plug the other end of the phone line into the phone line connector of your
telephone.
Table 2-1 In the box with your CPE, you should have
Item Description
potkseD eht stcennoc droc retpada rewoPretpadA rewoP CA
CPE to an AC electrical outlet.
tenretnI eht stcennoc elbac tenrehtE ehTel
baC tenrehtE
port on your Desktop CPE to your PC or
laptop computer.
Desktop CPEi 885 Quick Start Guide Desktop CPEi 885 Quick Start Guide
To Next Page
Loading...
Need help?
General
