5-8 Disassembly/Reassembly Procedures Radio Disassembly – Detailed
5. Remove the volume and channel knobs off from their shafts using the knob removal tool.
Figure 5-4. Volume and Channel Knob removal.
6. Separate the back kit from the front kit as follows:
a. Unscrew the screw using TORX T6 screwdriver as shown in Figure 5-5.
Figure 5-5. Front Kit-Back Kit Screw removal
NOTE
Both knobs slide on and off. However, they are supposed to fit very tightly on their shafts.
To Next Page
Loading...
