Motorola DTR600 - Charging a Stand-Alone Battery

1 Place the SUC on a flat surface.
2 Insert the connector of the power supply into the port
on the side of the SUC.
3 Plug the AC adapter into a power outlet.
4 Insert the radio into the SUC with the front of the
radio facing the LED of the SUC. Ensure the radio is
securely inserted all the way into the charger.
NOTICE:
To perform CPS programming, your radio
needs to be turned on before placing into the
SUC.
The red LED on the SUC illuminates to indicate that
the battery is charging.
Charging a Stand-Alone Battery
Insert the battery into the charging pocket with the
front of the battery facing the LED of the Single Unit
Charger (SUC).
1
2
The charger LED flashes a few times to indicate the
current battery charge when the radio is inserted in
the tray rails. The light on the charger is red to
English
20