Cloning Radio using the Radio to
Radio (R2R) Cloning Cable (Optional
Accessory)
Figure 2: Radio to Radio Cloning
1 Before starting the cloning process, ensure that you
have the following hardware:
• A Cloning Cable (P/N# HKKN4028_).
• A fully charged battery in each of the radios.
• Two Single-Unit Chargers (SUC) for radio
cloning.
• Ensure that the radios are turned off
2 Unplug any cables (power supply or USB cables)
from the SUCs.
3 Plug one side of the cloning cable mini USB
connector to the first SUC and the other end to the
second SUC.
NOTICE:
During the cloning process, no power is being
applied to the SUC. The batteries are not
charged. Only data communication is being
established between the two radios.
4 Turn on the Target Radio and place it into one of the
SUCs.
5 For the Source Radio, power on the radio with the
following sequence:
1 Press the PTT button and the (-) button
simultaneously while turning the radio on. Wait
three seconds before releasing the buttons and
English
53
To Next Page
Loading...
