1 Turn on the Target radio and place it into one of the
MUC Target Pockets.
2 Power the Source radio by performing the following
actions:
a Press the PTT button and the (-) button
simultaneously while turning the radio on.
b Wait for three seconds before releasing the
buttons until the audible tone and voice
announcement “Clone Mode Serial” are heard.
3 Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1step
1. Press and release the (+) button.
After cloning is completed, the Source radio will
announce either “pass” (cloning is successful) or
“fail” (cloning has failed).
4 After completing the cloning process, perform one of
the following actions:
• Turn the radios off and on.
• Exit the 'cloning' mode by long pressing the PTT
button
5 If cloning fails, refer to What To Do If Cloning Fails
on page 54.
When ordering the MUC, refer to P/N# PMLN7136_.
English
52
To Next Page
Loading...
