Identifying the Pager Controls
English
16
Reset button to listen to an incoming
message.
• Condition: Critically low battery alert
reminder
Action: To disable the automatic critical
battery alert reminder, press and release
the Reset button while the reminder is in
progress.
Conditioning Your Pager For
Operation
Follow the procedures described next to
condition your pager for operation.
1 Set the Function Switch to a tone-alert
position and power up the pager. You
hear four short beeps. The red and
yellow LED blinks indicating that the
device has been powered up.
2 Set the Function Switch to a monitor
position.
3 Listen for a transmission and adjust the
volume control to a comfortable
listening level.
4 If no transmission is heard, hold down
the Reset button and adjust the
background noise to a comfortable
listening level. If required, adjust the
volume level when a voice signal is
present.
5 Set the Function Switch to the desired
operating mode (e.g. Selective Call,
Monitor, or Scan with tone and/or
vibrate alert, etc.).
6800969001_EN.book Page 16 Monday, January 13, 2014 11:40 AM
To Next Page
Loading...
