EasyManua.ls Logo

Motorola MTP6650 - SDS Remote Control; Setting Remote Control; Setup

Motorola MTP6650
174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Play loud tone until user interaction
The radio plays a loud tone as in the Man Down (henceforth known as Fall Alert) feature until you
unlock the keypad (if needed) and press the appropriate soft key labeled Exit. The tone is played
through the speaker even if an accessory is attached.
The tone is not emitted when the radio is in one of the following states:
In a call
Temporarily disabled
Pseudo Off Mode
Ambience Listening Mode
Transmit Inhibit Mode (TXI)
Emergency Mode
Silent Emergency Mode
Covert Mode
Send firmware version and TEI
The radio sends back an SDS message with its firmware version and TEI.
NOTE: If the sending Individual Short Subscriber Identity (ISSI) is not on the Allowed ISSIs list,
the receiving radio ignores the task.
4.9.7.2
SDS Remote Control
NOTE: This is a Software Selling Feature. Only one type of remote control can be active on a
radio; either SDS or Status.
SDS Remote Control is a feature that enables remote control and configuration of the radio using
special SDS messages. The messages can be sent both in TMO and DMO (including the Repeater
Mode) by any radio capable of controlling other radios. During the execution of the Remote Control
messages, depending on your service provider settings, the radio can play a tone, vibrate, or display
an appropriate icon in the status icon area.
4.9.7.3
Setting Remote Control
This procedure describes how to toggle remote control.
Procedure:
1 From the home screen, press the Menu key.
2 Select SecurityRemote Control.
3 Select On to enable, or Off to disable remote control.
4.10
Setup
The Setup menu allows you to change the general configuration on your radio.
MN005826A01-AE
Chapter 4 : Main Menu
103

Table of Contents

Related product manuals