EasyManua.ls Logo

Motorola MTP6650 - Connecting or Disconnecting Devices; Devices; Pairing Bluetooth Devices with Your Radio

Motorola MTP6650
174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.6.3
Pairing Bluetooth Devices with Your Radio
Pairing is a process that creates a link between two Bluetooth-enabled devices. Once paired, devices
remember each other and every subsequent connection between them is authenticated automatically.
When and where to use:To scan for available Bluetooth-enabled devices and to connect with them.
Procedure:
1 From the home screen, press the Menu key.
2 Select BluetoothAdd Device. Ensure that the device you want to connect with is in pairing
mode.
The radio lists available devices that can be paired with your radio.
3 Highlight the required device and select Connect.
NOTE: Press accessory PTT button to improve the connection between the accessory
and radio.
4 If needed, enter a PIN code or a passkey.
NOTE: If you enter an incorrect PIN code and the subsequent paring attempts take too
long or result in an error message, power the Bluetooth device off and on. The radio
accepts 3 logging attempts.
4.6.4
Devices
This menu item lists all devices paired with your radio and allows you to perform the following
operations:
Connect a device.
View and change device details.
Disconnect a device.
Delete a device.
4.6.4.1
Connecting or Disconnecting Devices
Prerequisites:Only pre-approved sensor devices can be used. The service provider is responsible for
configuring the radio to work with specific devices. See Add Bluetooth Devices on page 142.
Procedure:
1 From the home screen, press the Menu key.
2 Select BluetoothDevices.
3 Highlight the required device and press Menu/OK. Select Connect/Disconnect.
NOTE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
MN005826A01-AE
Chapter 4 : Main Menu
92

Table of Contents

Related product manuals