Motorola MTP6650 - Setting Automatic Updates for the Time and Date; Setting the Date Format; Setting the Date Manually; Setting Time Offset

4.10.9.4
Setting the Date Format
Prerequisites:If Menu→Setup→Time & Date→Display is set to Time & Date or Date Only.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Time & Date→Format→Format Date.
3 Select (D – day, M – month, Y – year):
• DD/MM/YY
• MM/DD/YY
• DD-MON-YY
• YY/MM/DD
4.10.9.5
Setting the Date Manually
When and where to use:If the date cannot update automatically through the infrastructure.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Time & Date→Set→Set Date.
3 Enter current date using Navigation keys or keypad.
4 Press Done.
4.10.9.6
Setting Time Offset
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Time & Date→Set→Time Offset.
3 Enter time offset using Navigation keys.
NOTE: You can adjust the offset value, with 15 minute steps, up to 14 hours ahead or
behind.
4 Press Done.
4.10.9.7
Setting Automatic Updates for the Time and Date
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Time & Date→System Update.
3 Select one of the following options:
• Off – All the infrastructure information are ignored. The radio uses internal time and offset.
• Time Only – Time displayed is calculated from the offset programmed by your service
provider added or subtracted from the infrastructure time.
MN005826A01-AE
Chapter 4 : Main Menu
114