Motorola MTP6650 - Vibrate; Setting Detail Vibrate; Ring Style; Setting Ring Style

4.10.1
Vibrate
This sub-menu allows you to determine if your radio vibrates, or rings, or vibrates and then rings when
receiving a call.
4.10.1.1
Setting Detail Vibrate
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Vibrate→Custom....
3 Select one of the following options:
• Duplex Calls – Sets the vibrate settings for Phone, PABX, and Duplex Private calls.
• Simplex Calls – Sets the vibrate settings for Simplex Private Calls.
• Group Call – Sets the vibrate settings for Group Calls.
• Mail Rcvd – Sets the vibrate settings for status messages and text messages.
4 Select the required setting, and press Select.
NOTE:
If you choose Duplex Calls, Simplex Calls or Mail Rcvd, the settings available are:
• Vibe then Ring,
• Vibe Only,
• Ring Only.
If you choose Group Call, the settings available are:
• Vibe On,
• Vibe Off.
4.10.2
Ring Style
This sub-menu allows you to set the incoming call ring style.
4.10.2.1
Setting Ring Style
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Ring Style.
3 Select one of the following options:
• Duplex – To set the new ring style to all duplex calls.
• Simplex – To set the new ring style to all simplex calls.
• DMO Simplex – To set the new ring style to all Direct Mode Operation (DMO) simplex calls.
NOTE: Upon entry into this sub-menu, the display shows the current ring style used.
MN005826A01-AE
Chapter 4 : Main Menu
104