Motorola MTP6650 - Activating Talkgroup Scanning; Setting Scan Lists; Setting Talkgroups in the Active Scan List

4.11.2.1
Activating Talkgroup Scanning
When and where to use:If you want to monitor any TMO Group Call in the defined talkgroup list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Scan→Scanning.
3 Select Select List and then a list name.
Your radio displays list name selected.
4 Select Scanning→On.
Your radio is scanning on the predefined scan list.
4.11.2.2
Setting Talkgroups in the Active Scan List
When and where to use:If you want to edit talkgroups in the active scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Scan→Active List.
NOTE: If Scanning is Off is displayed, go to Group Setup→Scan→Scanning→On
to enable scanning.
3 Select View and highlight the required talkgroup.
4 Press Menu.
5 Select one of the following options:
• Delete – Erases this group from the active scan list.
• Priority and select new priority to Low, Medium or High.
4.11.2.3
Setting Scan Lists
When and where to use:If you want to set up any scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Scan→Scan Lists.
3 Highlight required scan list and press Menu to see additional settings:
• Rename – Enters new name for that scan list.
• Capacity – Displays the number of assigned and unassigned talkgroups for the scan list.
• Clear – Deletes all the talkgroup assigned to that scan list.
• Add Group – Adds a talkgroup to the scan list. Select one talkgroup from your talkgroup
folders and assign appropriate priority.
• Edit – Changes the priority of the required talkgroup or deletes it.
MN005826A01-AE
Chapter 4 : Main Menu
123