Icon Description
• Solid – when the radio has detected the repeater (for example, when the radio
receives a presence signal).
• Blinking – when the radio has not detected the repeater or during attachment.
• No icon – during a radio-to-radio and gateway communication.
General Icons
All Tones Off – Indicates that:
• Volume is set to 0 (when Volume Adj. Mode is set to Common).
• Both simplex and duplex ring volume is set to 0 (when Volume Adj. Mode is set
to Individual).
Simplex Ring Muted – Indicates that simplex ring volume is set to 0 and duplex ring
volume is set to more than 0.
Duplex Ring Muted – Indicates that duplex ring volume is set to 0 and simplex ring
volume is set to more than 0.
Vibrate Only – Indicates that the radio vibrates to alert you of an incoming message.
Vibrate then Ring – Indicates that the radio vibrates and then rings to alert you of an
incoming message.
Low Audio – Indicates that the audio mode is changed to low.
High Audio – Indicates that the audio mode is changed to high.
Permanent Disable in Car Kit.
Earpiece Connected – Indicates that the earpiece is connected.
GPS
• Solid – the radio has a location fix.
• Blinking – the radio is acquiring a location fix. This feature is an optional setting
and may not be enabled on your radio.
RUI Logged on – Indicates that you are logged on into the radio.
RUI Pseudo Log On – Indicates that you are in pseudo logged on state.
RUI Packet Data – Indicates Pseudo Log On state when the Packet Data feature is
activated and active data session is in progress.
RUI Packet Data – Indicates Pseudo Log On state when the Packet Data feature is
activated and the external device sets up data connection with the radio.
Battery Strength – Shows the charge of your battery.
Battery Charging – Indicates that the battery is charging.
MN005826A01-AE
Chapter 2 : Getting Started
36
To Next Page
Loading...
