19
English
SCAN
TALKBACK
If the programmable Talkback option is set, you can
respond to any calls received during the scan
operation by pressing the PTT before the
programmed hang-time ends. Check with your
dealer for details.
DELETING A NUISANCE CHANNEL
If a channel continually generates unwanted calls or
noise (a ÒnuisanceÓ Channel), you can temporarily
remove it from the scan list by performing a
Nuisance Channel Delete operation.
NOTE: You cannot perform a Nuisance Channel
Delete on a priority channel or if there is only
one remaining channel in the scan list.
ADDING A DELETED NUISANCE CHANNEL
BACK TO THE SCAN LIST
PRIORITIZATION OF A SCAN LIST
MEMBER
You may want your radio to check a particular
channel more frequently for calls. Prioritization of
scan list members is done by your dealer using the
Customer Programming Software. Check with your
dealer for details.
Even though your radio has switched to a non-
priority channel, your radio will still check for activity
on the priority channel. If activity is detected the
radio will switch to the priority channel.
1. While the radio is on the Nuisance Channel,
press the Nuisance Channel Delete button
(only available if programmed by your dealer)
until you hear a tone.
2. Release the Nuisance Channel Delete
button. The nuisance channel is deleted.
1. Press the Scan button to stop the scan
operation.
2. Press the Scan button again to re-start the
scan operation. The Deleted Nuisance
Channel is reinstated to the scan list.
Priority Channel Scanning Sequence
None speciÞed
Ch1
➠Ch2➠Ch3➠
Ch4➠...Ch1
Channel 2
Ch2
➠Ch1➠Ch2➠Ch3➠
Ch2➠Ch4➠Ch2➠...Ch1
To Next Page
Loading...
Need help?
General
