5.
Read RMS volts on the left LCD display in both
digital and analog form. Digital displays are for
accuracy and analog displays are for use during
peak-
ing and dipping adjustments.
6.
Simultaneously view the signal waveform on the
oscilloscope CRT.
NOTE: This feature can be used while the service monitor
is
either generating
or
monitoring a
RF
frequency
or
for
general purpose troubleshooting of an audio circuit. The
AC voltmeter bandwidth
is
specified to
10
KHz.
4-5
CIRCUIT BOARD
Q GEN 154.5500
II
~
1.76
VAC
L.___j
Vert/SINAD/Dist
DVM
UNDER
TEST
X1
PROBE
FIGURE
4-7-TEST
SET-UP FOR SIMULTANEOUS
OSCILLOSCOPE/DVM
MEASUREMENT
To Next Page
Loading...
