12 6/29/98
StarTAC 3000
25A# SAT/DSAT ON Enable the transmission of SAT when A = SAT
frequency or DSAT code.
Wide call processing mode:
A SAT Freq.
0 5970 Hz
1 6000 Hz
2 6030 Hz
Narrow call processing mode:
A DSAT Code
0 2556CB
1 255B2B
2 256A9B
3 25AD4D
4 26AB2B
5 26B2AD
6 2969AB
26# SAT/DSAT
OFF
Disable the transmission of SAT/DSAT
27# CDATA Transmit continuous control channel data. All words will
be the same as the “SETUP” command. When the
command starts the number of the command will be
displayed in the right side of the display.
Entering the
#
key will terminate the command. Trans-
mitter de-keys when finished.
28# HITNON Activate the high tone (1150 Hz +
55 Hz)
29# HITNOFF De-activate the high tone
30# LOTNON Activate the low tone (Frequency 770 Hz)
31# LOTNOFF De-activate the low tone
32# INVM Initialize non-volatile memory to factory default states.
This command should be reserved for special situa-
tions where reprogramming will be required (such as
memory chip or circuit board replacement or when a
radiotelephone is to be reissued to a new subscriber).
Does not reset ESN, NAM, phasing data or lock code.
NOTE: This command may take a minute or more to
complete; during which time the number 32
will be displayed. DO NOT turn off the radio-
telephone until the normal servicing level
display resumes.
33A# DTMFON Activate DTMF tone (A = DTMF digit, 0-9, *, #)
Table 3: Test Commands For Manual Test Mode
Keypad
Entry
Command
Description
Status
Display
Result
To Next Page
Loading...
