Radio Communications 4 - 19
MT20X0(s) To Cradle Support
Modes of Operation
The charging cradle with radio supports two radio communication modes of operation, allowing the device to
communicate wirelessly:
•
Point-to-Point
•
Multipoint-to-Point.
Point-to-Point Communication
In Point-to-Point communication mode, the cradle allows one device to connect to it at a time. In this mode, the
device is paired to the cradle either by insertion into the cradle (if pairing on contacts is enabled, page 4-22), or by
scanning the PAIR bar code on the cradle. Communication can be locked, unlocked (default), or in a lock override
state (see Pairing Modes on page 4-21). In locked mode, locking intervals must be set by scanning a connection
maintenance interval bar code beginning on page 4-23.
To activate this mode of operation, scan Point-to-Point.
Multipoint-to-Point Communication
In Multipoint-to-Point communication mode, up to seven devices can be paired to one cradle.
To activate this mode, the first device connected to the cradle must scan the Multipoint-to-Point bar code. This
mode allows a parameter broadcast (page 4-20) that clones all devices paired to the cradle so only one device
needs to be programmed.
To select Point-to-Point or Multipoint-to-Point mode, scan the appropriate bar code.
Multipoint-to-Point Mode
*Point-to-Point Mode
To Next Page
Loading...
