Motorola Symbol MT2070 - Special Commands; Pause Duration; Begin New Rule; Save Rule

Advanced Data Formatting 14 - 7
Special Commands
Pause Duration
Use this parameter, along with Send Pause on page 14-30, to insert a pause in the data transmission. Set the
pause by scanning a two-digit number (i.e., two bar codes) from Appendix D, Numeric Bar Codes in 0.1 second
intervals. For example, scanning bar codes 0 and 1 inserts a 0.1 second pause; 0 and 5 inserts a 0.5 second delay.
To correct an error or change a selection, scan Cancel on page D-3.
Pause Duration
Begin New Rule
Scan the bar code below to start entering a new rule
.
Begin New Rule
Save Rule
Scan the bar code below to save the rule.
Send Graphic User Interface (GUI) Characters 14-82
Send GUI 0
- Send GUI 9 14-82
Send GUI A
- Send GUI Z 14-83
Turn On/Off Rule Sets 14-87
Alphanumeric Keyboard 14-89
Space
- ‘ 14-89
0
- 9 14-93
A - Z 14-94
Cancel 14-98
End of Message 14-98
a
- z 14-98
{
- ~ 14-102
Table 14-1 ADF Bar Codes (Continued)
Parameter Page Number