Motorola Symbol MT2070 - Setup Field(S)

Advanced Data Formatting 14 - 29
Setup Field(s)
Send Data (continued)
Send Next 19 Characters
Send Next 20 Characters
Table 14-2 Setup Field(s) Definitions
Parameter Description Page Number
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character , then any printable ASCII
character from the
Alphanumeric Keyboard on page 14-89 . This
moves the cursor to the position after the matching character. If the
character is not there, the rule fails and ADF tries the next rule.
14-30
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the data. 14-30
Move Cursor Past a Character This action moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is ‘A’,
then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the
Move
Cursor Past Character
, then select a character from the
Alphanumeric Keyboard . If the character is not there, the cursor
does not move (i.e., has no effect).
14-30
Skip Ahead “N” Characters Scan one of these bar codes to select the number of positions
ahead to move the cursor.
14-31
Skip Back “N” Characters Scan one of these bar codes to select the number of positions back
to move the cursor.
14-32
Send Preset Value Send Values 1 through 6 by scanning the appropriate bar code. Set
these values using the prefix/suffix values in
Table 8-4 on page
8-19
.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
14-32