Operating the MT2070/MT2090 2 - 47
dialog, it is cached as usual, but it is not be used to initialize the username field the next time the interactive
credential dialog is shown for that profile; the username field is initialized to blank. In summary, the user can control
whether the username field in the interactive credential dialog is initialized, either with the last-interactively-entered
username for that profile or with the username entered into the profile, by whether any value is entered in the Enter
User Name field during profile entry.
Figure 2-53
Username Dialog Box
Password
Use the Password dialog to enter a password. If EAP/TLS is the selected authentication type, the password dialog
does not display. Note that if a username was entered and no password is entered, Fusion assumes that no
password is a valid password.
Figure 2-54
Password Dialog Box
1. Enter a password in the Enter Password field. If an authentication tunnel type of EAP-GTC is used, a
Password dialog with additional radio buttons displays.
Figure 2-55
EAP-GTC Password Dialog Box
To Next Page
Loading...
