Motorola Symbol MT2090 - Page 498

A - 2 Symbol MT2070/MT2090 User Guide
Parameter Broadcast (Cradle Host Only) Enable 4-20
Pairing Modes Unlocked 4-20
Pairing on Contacts Disable 4-20
Connection Maintenance Interval 15 min 4-23
Authentication Disable 4-26
Variable Pin Code Static 4-27
Encryption Disable 4-28
User Preferences
Set Default Parameter Set Defaults 5-4
Host Mode Cable Priority 5-5
Decode Pager Motor Enable Disable 5-6
Parameter Bar Code Scanning Enable 5-7
Beep After Good Decode Enable 5-7
Beeper Tone Medium 5-8
Beeper Volume High 5-9
Hand-Held Trigger Mode Standard (Level) 5-10
Picklist Mode Disabled Always 5-11
Decode Session Timeout 9.9 Sec 5-10
Timeout Between Decodes, Same Symbol 0.5 Sec 5-12
Hand-Held Decode Aiming Pattern Enable 5-12
Decoding Illumination Enable 5-13
Batch Mode No Batch Mode 5-14
Miscellaneous Options
Transmit Code ID Character None 5-16
Prefix Value 7013 <CR><LF> 5-17
Suffix 1 Value
Suffix 2 Value
7013 <CR><LF> 5-17
Scan Data Transmission Format Data as is 5-18
FN1 Substitution Values Set 5-19
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.