Motorola Symbol MT2090 - Page 499

Standard Default Parameters A - 3
Transmit “No Read” Message Disable 5-20
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type IBM PC/AT& IBM PC Compatibles 11-4
Country Types (Country Codes) North American 11-5
Ignore Unknown Characters Transmit 11-7
Keystroke Delay No Delay 11-7
Intra-Keystroke Delay Disable 11-8
Alternate Numeric Keypad Emulation Disable 11-8
Caps Lock On Disable 11-9
Caps Lock Override Disable 11-9
Convert Wedge Data No Convert 11-10
Function Key Mapping Disable 11-10
FN1 Substitution Disable 11-11
Send and Make Break Send 11-11
RS-232 Host Parameters
RS-232 Host Types Standard 8-6
Baud Rate 9600 8-7
Parity Type None 8-9
Stop Bit Select 1 Stop Bit 8-10
Data Bits 8-Bit 8-10
Check Receive Errors Enable 8-11
Hardware Handshaking None 8-11
Software Handshaking None 8-13
Host Serial Response Time-out 2 Sec 8-15
RTS Line State Low RTS 8-16
Beep on <BEL> Disable 8-16
Intercharacter Delay 0 msec 8-17
Nixdorf Beep/LED Options Normal Operation 8-18
Ignore Unknown Characters Send Bar Code 8-18
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.