Your service provider can configure the radio to play a tone each time it connects to or disconnects from the repeater.
Communication through Gateways
Gateway provides connectivity between radios operating in DMO Mode and the TETRA network, so that the DMO
radios can communicate with the TMO radios.
Your service provider can configure the radio to play a tone each time it connects to or disconnects from the gateway.
Hibernation
Normally, the radio can be turned on or off only using the dedicated button. However, there is a possibility to switch
the radio to stand-by mode.
In stand-by mode, the radio has all the signaling, all the audio, GPS, RF, and everything other than the PEI port for
AT commands shut down. The radio is not registered to the network and does not stay on the cell. The radio
consumes minimal power in this mode.
To switch into the standby mode, press the VOLUME UP and VOLUME DOWN buttons for a minimum of 2 seconds
simultaneously. Switching back on into normal operation requires the same sequence. Afterwards the radio turns on
as usual.
46 | Services and Features
Send Feedback | |
To Next Page
Loading...
